Imed Google Docs Autocomplete Knows Where You d Rather Be
Serena Williams personifies intensity on a tennis court, right down to her routine for the pre-match coin toss.Up at the net, most players are blank canvases, cradling a racket and generally standing still during the formality. Not Williams. She whips her arm in a service motion over and over, her
stanley cup racket slicing the air in a display akin to shadowboxing during a referee s instructions in a ring.Bringing that intimidation to every shot on every surface against every opponent including, finally, her older sister in 2002, Williams was simply dominant, winning three of the four Grand Slam titles.On Friday, Williams was honored as The Associated Press Female Athlete of the Year in a vote that was about as close as many of her matches.She received 53 first-place votes and 351 points from w
stanley tumbler riters and broadcasters across the country. Golfer Annika Sorenstam was next, with 27 first-place votes and 193 points, followed by Olympic champion figure skater Sarah Hughes 12 first-place votes, 158 points . I can t become satisfied, because if I get satisfied, I ll be like, Oh, I ve won Wimbledon, I ve won the U.S. Open. Now can I relax, Williams said. But now people are really going to be fighting to beat me. It d
stanley kubek idn t do a lot of good to try to beat her this year.Williams won 56 of 61 matches a .918 winning percentage , claimed a WTA Tour-leading eight titles out of only 13 tournaments played , and took home a record $3.6 million. She was a runner-up twice and never fared wo Vbfg Facebook Apologizes Over Real Name Policy But Doesn t Back Down (Yet)
3D printing in its current guise is kinda cool, but also limited by its use of plastic 鈥?there only so many combs you can print before you get bored. An affordable 3D printer that uses metal would be a major step up in practicality, which is exactly what this team is hoping to achieve by mating a MIG welder to a conventional 3D printer. The team from Delft is following in the footsteps of researchers from Michigan Tech, who last year also created a 3D printer that used a welder. That project, however, laid down sheets of steel, which were then combined with the welder. D
stanley cup elft approach is different:
stanley termoska it feeds a small spool of wire to the welder, which is then laid down layer by layer to create an object, exactly like in the plastic Prusia i3 it based on. At this stage, though, performance isn ;t really close to plastic printers: the 3D welder feeds wire at a rate of 300mm/minute, compared to the 10,000mm/minute you can expect from a decent 3D printer. Still, wi
stanley becher th the open-source nature of the project, and the relatively low cost, this is promising attempt to make metal 3D printing affordable. [3D Print] 3D printing